LD-5 and Linux?

Home › Forums › QRP Transceivers › LD-5 and Linux?

Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
    Posts
  • January 27, 2017 at 1:42 pm #3272
    Scott_WZ0W
    Member

    Has anyone had any success getting CAT control for the LD-5 working under Linux? I have control of my Yaesu FT-450D working fine, but can’t seem to hit on the right combination of settings to get my Raspberry Pi or Xubuntu Laptop to work. The device shows up when I use lsusb, and I can see /dev/ttyUSB0 is the device. I’m using the Kenwood TS-2000 as the rig model for hamlib, with the settings indicated in the document on LNR’s website, but when I try to connect to it, there is either no response, or the radio goes into transmit mode.

    Thanks,
    Scott WZ0W

    January 27, 2017 at 3:03 pm #3273
    QRPME
    Participant

    Scott,
    Not to my knowledge. But the LD-5 is the same protocol as the kenwood 2000.

    January 27, 2017 at 3:38 pm #3275
    Scott_WZ0W
    Member

    OK, thanks. I’ve managed to get communication started with flrig, which by itself is not particularly useful. However, it indicates that it is possible. Primarily I am hoping to get the LD-5 connected to CQRLog but so far no joy.

  • Author
    Posts
Viewing 3 posts - 1 through 3 (of 3 total)
  • You must be logged in to reply to this topic.